• Konfen Kitesurfing

  andvänd pumpen

  Publicerad av roland på 13 september, 2004 vid 12:05

  3 PUMP

  Amongst all the hype generated by all the manufacturers at this time of year about new ground breaking products, one innovation is sure to change the way many kiteboarders think (at least for a few hours) – 3 Pump.

  3 Pump takes the beer-bong to a new level allowing the consumption of over 4 beers in just 3 small pumps and requires just a slightly modified pump making it accessible to all kiteboarders. Any one with more that one kite can simply use their spare pump, those with just the one kite might have to blow their kite up by mouth from now on.

  MATERIALS
  Ø 2 foot of PVC tube
  Ø 2 hose clamps
  Ø At least 1 slab
  Ø 1 assistant
  Ø A crowd

  CONSTRUCTION
  Clean the inside of the pump out if it’s been used a bit to get out all the sand, dirt, rubber and grease that accumulates in there. For ease of use, it is worthwhile changing the pumps hose to a piece of clear PVC tubing fastened with hose clamps and ensure each end is sealed tight. It’s that simple!

  METHOD
  Unscrew the top of the pump and fill it with beer (or anything else). Make sure the pump handle is fully up. It should take about 4.5 beers to fill it then scoop out the excess froth. Push the pump down until the hose is filled with beer. Place the hose end into your mouth. Get your assistant to pump down at a steady speed and just open your throat. It will take about 3 pumps to fully drain the pump.

  honk svarade 21 år, 1 månad sedan 2 Medlemmar · 1 Svar
• 1 Svar

• 

  honk

  Medlem

  13 september, 2004 vid 14:02

  Det är ju hur bra som helst… slipper man ha med massa extra öl och skit oxå utan man fyller alla pumpar med öl redan innan man åker.. så får man helt enkelt se till att dricka upp innan man skall surfa

Logga in för att svara